Weed Eater 545186763, XT110S, SG14, SG10, 952711326, 952711329 Troubleshooting Table, Cause, Remedy

TROUBLESHOOTING TABLE

WARNING: Always stop unit and disconnect from the power source before performing all of the recommended remedies below except remedies that re- quire operation of the unit.

TROUBLE	CAUSE		REMEDY
Semi-automatic	1.	Crowding trimmer line	1.	Allow tip of line to do the cutting.
head stops		against material being
under a load or		cut.	2.	Contact your authorized service dealer.
does not turn	2.	Electrical failure.
when switch is	3.	Thrown circuit breaker.	3.	Check Breaker Box.
pressed.	4.	Debris stopping head.	4.	Remove debris.
Line does not	1.	Line improperly routed	1.	Check line routing.
advance or		in head.
breaks while	2.	Line improperly	2.	Rewind line tightly and evenly.
cutting.		wound onto spool.	3.	Use only .065 in. (1.65mm) dia. line.
	3.	Incorrect line size
	4.	Not enough line	4.	Remove cover and pull 4 in.
		outside of head.		(10 cm) of line out of head.
	5.	Dirt buildup on unit.	5.	Clean unit.
Line welds onto	1.	Line size is incorrect.	1. Use only .065 in. (1.65mm) dia. line.
spool.	2.	Incorrect spool.	2. Replace with correct spool.
	3.	Line is being crowded	3. Cut with tip of line fully extended.
		against material being
		cut.
Line releases	1.	Line improperly	1. Check line routing.
continuously.		routed in head.
	2.	Spool damaged.	2. Replace spool.
Line usage is	1.	Line improperly routed	1. Check line routing.
excessive.		in head.
	2.	Line size is incorrect.	2. Replace spool.
	3.	Crowding line against	3. Cut with tip of line fully extended.
		material being cut.	4. Replace spool.
	4.	Spool worn or damaged.
Line pulls back	1. Too little line outside		1. Remove cover and pull 4 in.
into head.		of head.		(10 cm) of line outside of head.
	2. Line size incorrect.		2. Use only .065 in. (1.65 mm) dia. line.

7