Wegener Communications 550 quick start Rear Panel Connections, Front Panel Connections

QUICK START GUIDE

Rear Panel Connections

Figure 1 shows the rear panel connections of the Unity 550 that are described in Figure 1.

Figure 1: Unity 550 rear panel view

Table 1: Unity 550 Interconnect Descriptions

Signal	Connector		Description
RF Switch IN - Port 1	F	950 to 2150	MHz signal accepted. LNB power available
RF Switch IN - Port 2, 3, 4	F	950 to 2150	MHz signal accepted. NO LNB power available
Main Video OUT	Phono Jack	NTSC or PAL, Composite video at 1 Vp-p
Monitor Video OUT	Phono Jack	NTSC or PAL, Composite video at 1 Vp-p
Audio OUT 1 (R & L)	Two Phono Jacks	Audio stereo
Audio OUT 2 (R & L)	Two Phono Jacks	Audio stereo
RS232 Port	RJ-12	Serial Asynchronous Data. May be used for terminal, printer, or
		modem (to remote terminal)

CAUTION: Do not connect RJ-12 directly to phone line. Equipment damage may result

Front Panel Connections

Figure 2 show the Unity 550 front panel controls and describes them in Table 2. The IRD can be controlled via COMPEL Network Control, local terminal, modem (remote terminal) and On-Screen- Display push buttons. Normally, COMPEL is the primary method of controlling the IRD, while the other control methods are supplemental.

Figure 2: Unity 550 Front Panel

top arrow

	button
left arrow		right arrow		LED
button			button

LCD	bottom	arrow	Enter
screen			button
	button

www.wegener.com 800072-02B 3