7.Attach one Backrest Tube (5) to the Backrest (6) with two M6 x 38mm Screws (16) and two M6 Washers (26). Attach the other Backrest Tube to the Backrest with one M6 x 38mm Screw and one M6 Washer. Note: Do not tighten the three

Screws yet. A fourth M6 x 38mm Screw will be attached at the end of step 8.

8.Tap a 3/4” Round Inner Cap (9) into each end of the Support Rod (7). Insert the Support Rod through one of the three sets of holes in the Uprights (1). Rotate the Support Rod to the locked position, with the end of the Support Rod clipped onto the Upright.

See the inset drawing. Slide the ends of both Backrest Tubes (5) onto the pin on the Frame (2). Attach the free end of the Backrest Tube (5) to the Backrest (6) with an M6 x 38mm Screw (16) and an M6 Washer (26). Fully tighten all four M6 x 38mm Screws.

9.Attach the Seat (11) to the brackets on the Frame

(2) with four M6 x 16mm Screws (15) and four M6 Washers (26).

7

 

 

16

16

 

 

 

 

 

 

 

 

26

 

 

 

 

26

 

 

 

 

 

 

 

 

5

 

 

 

 

16

 

 

 

 

 

26

 

 

 

 

 

 

 

 

6

 

8

 

 

1

6

 

 

 

 

 

 

 

 

 

9

5

 

 

 

 

 

2

 

 

 

 

 

 

6

 

 

Pin

5

 

 

 

 

 

 

 

 

 

 

 

 

 

 

9

 

 

 

2

7

 

 

 

 

 

 

 

 

26

 

1

 

 

5

16

 

 

 

9

11

 

 

 

 

 

 

 

 

 

 

2

 

26

 

 

 

 

 

 

 

 

26

 

 

 

 

 

 

 

15

 

 

8

Page 8
Image 8
Weider 831.150280 user manual