Before beginning assembly, carefully read the
following information and instructions:
•Assembly requires two people.
•For help identifying small parts, refer to the PART
IDENTIFICATION CHART.
•Tighten all parts as you assemble them, unless
instructed to do otherwise.
•As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
•Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
The following tools (not included) are required
for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
• Lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Things Easier for Yourself
This manual is designed to ensure that the
weight bench can be assembled successfully
by anyone. Most people find that by setting
aside plenty of time, assembly will go smoothly.
ASSEMBLY
5
2
1
17
17
37
Indents
13
22
8
22
22
3
Decal
18
15
18
16
17
1
21
21
1
Tall sides of
Weight Rests
1.
Tap two 38mm Square Inner Caps (21) into the
bottom of an Upright (1). Tap a Fly Arm Stop (15)
onto the welded tube on the Upright.
Attach the Crossbar (3) to the Upright (1) with two
M8 x 55mm Bolts (18), two M8 Washers (16), and
two M8 Nylon Locknuts (17). Note: The decal on
the Crossbar must be oriented as shown. Do
not tighten the Locknuts yet.
Repeat this step with the other Upright (1).
2. Tap three 30mm Square Inner Caps (22) into the
Front Leg (8) and the Stabilizer (13).
Attach the Front Leg (8) to the Stabilizer (13) with
two M8 x 42mm Carriage Bolts (37) and two M8
Nylon Locknuts (17). Note: The indents around
the holes on one side of the Stabilizer must be
on the bottom. Do not tighten the Locknuts yet.
Before assembling the weight bench, make
sure that you have read and understand the
information in the box above. For help
identifying small parts, refer to the PART
IDENTIFICATION CHART.