8. Tap four 25mm Square Inner Caps (35) into the
ends of the two Backrest Tubes (5).
Attach the Backrest Tubes (5) to the Backrest (6)
with four M6 x 38mm Screws (30) and four M6
Washers (26). Do not tighten the Screws yet.
9. Tap a 19mm Round Inner Cap (9) into each end
of the Support Rod (7). Insert the Support Rod
through a set of holes in the Uprights (1). Rotate
the Support Rod to the locked position, with the
locking pin wrapped around the Upright.
Lubricate the M10 x 137mm Bolt (36) with
grease. Attach the Backrest Tubes (5) to the
welded tube on the Frame (2) with the Bolt, two
M10 Washers (34), and an M10 Nylon Locknut
(33). Do not overtighten the Locknuts; the
Backrest Tubes must be able to pivot easily.
Tighten the Nylon Locknuts (17, 33) used in
steps 1–4. Tighten the M6 x 38mm Screws (30)
used in step 8.
10. Attach the Seat (11) to the brackets on the Frame
(2) with four M6 x 16mm Screws (29).
7
8
530
26 26
26
26
30
6
35
35
9
9
9
34
5
36 7
1
2
Welded
Tube
1
Locking
Pin
33
34
10
11
29
2
11. Tap two 30mm Square Inner Caps (22) into the
ends of a Fly Arm (25). Press a 25mm Round
Inner Cap (24) into the end of the weight tube.
Slide a Weight Stop (28) onto the weight tube.
Assemble the other Fly Arm (not shown) in
the same manner.
11
28
24
22 Weight
Tube
22
25