Weider 831.150721 user manual Assembly, Make Things Easier for Yourself

ASSEMBLY

Make Things Easier for Yourself

Everything in this manual is designed to ensure that the weight bench can be assembled suc- cessfully by anyone. However, it is important to realize that the versatile weight bench has many parts and that the assembly process will take time. Most people find that by setting aside plen- ty of time, assembly will go smoothly.

Before beginning assembly, carefully read the following information and instructions:

•Assembly requires two people.

•As you assemble the weight bench, make sure all parts are oriented as shown in the drawings.

•For help identifying small parts, use the PART IDENTIFICATION CHART on page 5.

The following tools (not included) are required for assembly:

• Two adjustable wrenches

• One rubber mallet

• One standard screwdriver

• One Phillips screwdriver

•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

•Tighten all parts as you assemble them, unless instructed to do otherwise.

•Lubricant, such as grease or petroleum jelly, and soapy water.

Assembly will be more convenient if you have a socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches.

1.Before assembling this product, be sure that you have read and understand the information in the box above.

Slide the Right Crossbar (3) into the Left Crossbar (2), with the decal on top. Note: the crossbar can be adjusted for use with either a standard barbell or a mid-width barbell. For a standard barbell, align the set of holes indicat- ed by the arrows. For a mid-width barbell, align the holes on the ends of the Crossbars.

Attach the Frame (4) to the Crossbars (2, 3) with two M8 x 65mm Bolts (20), two M8 x 55mm Bolts (18), and four M8 Nylon Locknuts (24). Note: The

Bolts should fit inside of the holes in the Left Crossbar (2). Do not tighten the Nylon Locknuts yet.

2.Insert a 38mm Square Inner Cap (17) into the Front Leg (5).

Slide the welded tube on the Front Leg (5) into the Frame (4). Secure the Front Leg with two M8 x 40mm Carriage Bolts (28), two M8 Washers (26), and two M8 Nylon Locknuts (24). Do not tighten the Nylon Locknuts yet.

1
	3
20		2
	18	Decal
4
24
24
2	28
	17
		4
		26
5		24

6