9.Insert a Pad Tube (19) into the Leg Lever (3). Slide two Foam Pads (20) onto the Pad Tube.
Repeat this step with the other two Pad Tubes (19) and the Leg Lever (3) and Front Leg (2).
10.Attach the Curl Pad (15) to the Curl Post (11) with two M6 x 16mm Screws (39).
11.Route the Lat Cable (35) through the Lat Tower
(8)and over the Pulley (38). Make sure that the Cable is under the lat rest bar. Attach the Pulley inside the Lat Tower with an M10 x 60mm Bolt (47), two M10 Washers (44), two 10mm Large Spacers (31), and an M10 Nylon Locknut
12.Insert an M10 x 19mm Bolt (53) into the bracket on the Weight Carriage (9).
Slide the Weight Carriage (9) onto the Lat Tower
(8). Make sure the bracket on the Weight
Carriage and the lat rest on the Lat Tower (see step 11) are on opposite sides of the Lat Tower. Attach the Lat Cable (35) to the M10 x 19mm Bolt (53) with an M10 Nylon Locknut (43).
13.Make sure that all parts are properly tightened before the weight bench is used. The use of all remaining parts will be explained in ADJUST- MENTS, beginning on the following page.
9 |
|
| |
|
| 2 | |
3 |
| 19 | |
20 |
|
| |
|
| 19 | |
|
| 20 | |
| 19 |
| |
10 |
| 15 | |
|
| ||
|
| 11 | |
|
| 39 | |
11 |
| Lat Rest | |
43 | 31 | ||
Bar | |||
| |||
44 |
| 35 | |
|
| ||
|
| 44 | |
| 38 | 31 | |
|
| 47 | |
|
| 8 | |
12 |
|
| |
35 |
| 8 | |
|
| ||
43 |
|
| |
|
| 53 | |
Bracket |
|
| |
| 9 |
|
8
