7.Lubricate the M10 x 178mm Bolt (17). Attach the Backrest Tubes (5, 42) to the Frame (2) with the Bolt, two M10 Washers (24), and an M10 Nylon Locknut (19).
Secure the Backrest (6) to the Frame (2) with the Adjustment Pin (32) through one of the three sets of holes in the adjustment tubes. Secure the Adjustment Pin with the Pin Clip (27).
Make sure the Adjustment Pin (32) is com- pletely inserted through both holes in the adjustment tubes.
8.With the wide end of the Seat (11) positioned as shown, attach the Seat to the brackets on the Frame (2) with four M6 x 16mm Screws (15).
9.Tap two 3/4Ó Round Inner Caps (9) into each Pad Tube (10). Insert the Pad Tubes into the holes in the Leg Lever (4) and the Front Leg (8). Slide two Foam Pads (22) onto each Pad Tube.
7 | 6 |
|
5 |
|
|
32 | 42 | Adjustment |
| ||
|
| |
17ÑLubricate |
| Tubes |
24 |
| |
|
| |
| 19 | 2 |
| 27 | |
8 |
|
|
11 |
|
|
Wide |
|
|
End |
|
|
| 2 |
|
| 15 |
|
9 |
|
|
22 |
|
|
4 |
|
|
| 8 | 10 |
|
| |
| 9 |
|
| 10 | 22 |
10.Make sure that all parts are properly tightened before you use the weight bench. The use of all remaining parts will be explained in USING THE WEIGHT BENCH on pages 9 and 10.
8
