3.Attach the Front Leg (3) to the Bench Frame (1) using two Joint Plates (12), four M10 x 70mm Bolts (31), and four M10 Nylon Locknuts (11).
Tighten the M10 Nylon Locknuts (11) used in steps 1–3.
Insert the Bench Knob (21) into the Bench Frame
(1) and tighten it fully.
4.Press three 45mm Square Inner Caps (26) into the Leg Lever (8). Press a 25mm Round Inner Cap (23) into the indicated end of the Weight Tube (9).
Attach the Weight Tube (9) to the Leg Lever (8) with an M8 x 55mm Bolt (38), two M8 Washers (41), a 10mm Spacer (39), and an M8 Nylon Locknut (34).
Press an Angled Outer Cap (25) onto the back end of the Weight Tube (9).
5.Lubricate an M10 x 70mm Bolt (31). Attach the Leg Lever (8) to the Front Leg (3) with the Bolt and an M10 Nylon Locknut (11). Do not over- tighten the Nylon Locknut; the Leg Lever must be able to pivot freely.
6.Press four 25mm Square Inner Caps (27) into the ends of the Backrest Frames (33).
Attach the Backrest Bracket (5) to the Backrest Frames (33) with four M10 x 45mm Bolts (40), four M10 Washers (6), and four M10 Nylon Locknuts (11). Do not tighten the Nylon
Locknuts yet.
3 |
|
| 21 |
|
|
| |
11 | 12 | 1 |
|
|
|
| |
3 | 12 |
|
|
|
| 31 | |
|
|
| |
4 | 26 |
| |
|
| ||
72 |
|
|
|
26 |
|
|
|
|
| 41 | 25 |
34 | 39 |
|
|
|
| 41 | |
|
|
| |
23 |
|
|
|
9 |
| 26 | 38 |
|
|
| |
5 |
|
|
|
11 |
|
|
|
8 |
|
|
|
| 3 |
| 31 |
|
|
| |
|
|
| Lubricate |
6 |
|
| 27 |
|
|
| |
|
| 33 |
|
11 | 6 |
|
|
6 |
| 6 |
|
|
|
| |
27 | 6 | 11 |
|
| 40 |
| |
|
|
| |
40 |
|
|
|
5 | 40 |
| |
|
| ||
6
