Before beginning assembly, carefully read the
following information and instructions:
•Assembly requires two persons.
•Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
•Tighten all parts as you assemble them, unless
instructed to do otherwise.
•As you assemble the resistance system accesso-
ry, make sure that all parts are oriented as shown
in the drawings.
The following tools (not included) are required
for assembly:
• One adjustable wrench
• One rubber mallet
• One Phillips screwdriver
• Two Allen wrenches
(included with the
resistance system)
4
2. Slide the two Pad Tubes (F) removed in step 1
into the new Leg Lever (9). Slide the four Large
Foam Pads (E) onto the Pad Tubes.
2
F
E
FE
E
E9
1. Remove the Cotter Pin (A) from the lower Leg
Station Pin (B). Remove the Leg Station Pin from
the original Leg (C). Remove the Cable (S) from
the original Leg Lever (D).
Remove the Cotter Pin (A) from the upper Leg
Station Pin (B). Remove the Leg Station Pin from
the Leg (C) and the Leg Lever (D).
Remove the two Large Foam Pads (E) and the
Pad Tube (F) from the Leg Lever (D). Set the Leg
Lever aside.
Remove the two Large Foam Pads (E) and the
Pad Tube (F) from the Leg (C).
1
C
D
E
E
E
E
F
B
A
B
S
A
F
Make Things Easier for Yourself
This manual is designed to ensure that the resist-
ance system accessory can be assembled suc-
cessfully by most people.
ASSEMBLY