24.Slide an end of the Long Cable (80) through the Pulley Arm (22). Wrap the Cable around a 90mm Pulley (28). Attach the Pulley to the Pulley Arm with an M10 x 40mm Bolt (71) and an M10 Nylon Locknut (76).
25.Locate the Bench Cable (32). It has three ends, two that are the same length, and a third that is longer.
Route the long end of the Bench Cable (32) through the hole in the Front Leg (6), and attach it inside the hole in the Leg Lever (7) with an M10 x 60mm Bolt (63), two M10 Washers (75), and an M10 Nylon Locknut (76).
26.Attach a 90mm Pulley (28) inside the hole in the Front Leg (6) with an M10 x 66 mm Bolt (79), two 12.5mm Spacers (52), two M10 Washers (75), and an M10 Nylon Locknut (76). Be sure the Pulley is over the Bench Cable (32).
Slide the two free ends of the Bench Cable (32) onto the eyebolt welded to the bottom of the Bench Frame (5).
27.Locate the two Short Cables (33). Wrap a Short Cable around a 90mm Pulley (28). Attach the Pulley to a Pulley Housing (21) with an M10 x 40mm Bolt (71) and an M10 Nylon Locknut (76).
Repeat this step with the other Short Cable (33).
24
71
80
28 |
76 |
25 |
63 |
32 | 6 | 75 |
76 |
| 7 |
|
| |
| 75 |
|
26 |
5 |
75 |
79
Eyebolt | 32 | 28 | 52 |
|
| 75 |
|
52 
76 
27
21
71
76 |
|
28 | 33 |
|
12
