Weider WESY19511 user manual Troubleshooting and Maintenance, Tightening the Cables

TROUBLESHOOTING AND MAINTENANCE

Inspect and tighten all parts each time you use the weight system. Replace any worn parts immediately. The weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.

TIGHTENING THE CABLES

Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is slack in the cables before resistance is felt, the cables should be tightened. Slack can be removed from the cables by tightening the M8 Nylon Locknuts (3) at the end of the Long Cable (23) (see inset drawing A) and at the end of the Short Cable

(58)(see inset drawing B). To do this you may need to remove the Small “U”-Bracket (67) from the Weight Tube (63) or remove the 90mm Pulley (15) from the Long “U”-Bracket (57). Make sure that the cables are not too tight, or the Top Weight (76) will be lifted off the weight stack.

Additional slack can be removed by moving the 90mm Pulley (15) to the lower hole in the Long “U”- Bracket (57). Remove the M10 Nylon Locknut (21) and the M10 x 50mm Bolt (12) from the Cable Trap (66), Pulley, and “U”-Bracket. Re-attach the Pulley and Cable Trap. Be sure that the Cable Trap is posi- tioned to hold the Cable in place, and that the Cable and Pulley move smoothly.

Note: If a cable tends to slip off the pulleys often, the cable may have become twisted. Remove the cable and re-install it.

If the cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual.

A
	23
63	67
76
	23
	3
	67
B
23	15
66	57
21	12
3	58

19