Weider WESY19511 user manual Arm. Arm identification is very important for Step

8.	Press a 38mm Square Inner Cap (44) into the top	8				44
	of a Press Arm (46). Press a 25mm Round Inner
	Cap (49) into each end of the handle on the
	Press Arm.					49
	Attach the Press Arm (46) to one side of the		44		49
	Press Frame (17) with two M8 x 62mm Bolts (22)
						46
	and two M8 Nylon Locknuts (3).		49
	Assemble the other Press Arm (46) in the same		46		22
	manner.
						3
						17
9.	Identify the Right Arm (48) and the Left Arm (47).	9			7	50
	Note the position of the welded bracket on each			50
						6
	Arm. Arm identification is very important for			6
	step 10.
	Note: The “V”-Pulleys (6), Long Cable Traps (50),		Welded			47
			Brackets
	M10 x 60mm Bolts (7), and M10 Nylon Locknuts					21
	(21) are pre-attached. These have been shown
	disassembled for easy part identification.
			48
10.	Lubricate both axles on the Top Frame (55).	10			55
						47
	Press a 28mm x 63mm Plastic Bushing (74) into
	the Right Arm (48). Slide the Right Arm onto the
	right axle on the Top Frame (55). Note: Be care-
	ful not to confuse the Right Arm with the Left					Bracket
	Arm (47); refer to step 9 to identify the Right					Lubricate
	Arm. Be sure that the upper end of the Right		74
	Arm is behind the indicated bracket on the
	Top Frame.		48			69
	Tap two 25mm Retainers (69) and a 25mm					70
	Round Cover Cap (70) onto the right axle. Be					45
	sure that the teeth on the Retainers bend
	toward the Cover Cap, as shown in the inset
	drawing.
	Attach the Left Arm (47) in the same manner.
	Press a 38mm Square Inner Cap (44) into the		44
	lower ends of the Right and Left Arms (47, 48).
	Wet the end of each Arm with soapy water, and					55
	slide a Large Foam Pad (45) onto the Arm.		45
						69
						70
		8