Weider WESY39310 user manual Cable Assembly

15.See the inset drawing. Attach the Military Press Arm (84) to the Pivot Arm (80) with two 5/16” x

2 1/4” Bolts (33) and two 5/16” Nylon Locknuts (3).

Press two 1 1/2” Square Inner Caps (32) into the indicated end of the Military Press Arm (84). Press two 1” Round Inner Caps (49) into the Military Press Arm.

Attach the Pivot Arm (80) to the Rear Upright (74) with a 3/8” x 3 1/4” Bolt (67) and a 3/8” Nylon Locknut (21).

CABLE ASSEMBLY

16.Locate and open the parts bags labeled “CABLE ASSEMBLY” and “PULLEYS.”

During steps 16 through 36, refer to the CABLE DIAGRAMS on pages 25–26 of this manual to verify proper cable routing. Before beginning this section, fully unwind the four Cables. Identify the four Cables by comparing the lengths and ends of the Cables. The approximate length of each Cable is listed (in inches) after the key number in the drawing.

IMPORTANT: While assembling the cables, do not over tighten the bolts and nuts attaching the pulleys; the pulleys must be able to turn freely.

17.Locate the High Cable (58). Wrap the High Cable around a 3 1/2” Pulley (15). Attach the Pulley to the Top Frame (55) with a 3/8” x 3 3/4” Bolt (88) and a 3/8” Nylon Locknut (21). Be sure that the end of the Cable with the ball is on the indicated side of the Pulley and that the Cable is between the Pulley and the hook.

11

15		32
		49
		32
21		84
80
	67
74		56
	33
	80
		84
	3
16
		23—78.25”
		58—146.25”
		72—238.5”
		78—63.375”
17
21	55	58
	15
Ball	Hook	88