4.Press a 2” Square Inner Cap (27) into the end of the Top Frame (55). Press a 1 3/4” Square Inner Cap (44) into each end of the crossbar on the Top Frame. Press two Round Inner Caps (75) into the top of the crossbar.
Attach the Top Frame (55) to the Rear Upright (74) and the Leg Press Upright (56) with two 5/16” x
2 3/4” Bolts (11) and two 5/16” Nylon Locknuts (3).
Attach the Top Frame (55) to the Front Upright (42) with two 5/16” x 2 3/4” Bolts (11), two 5/16” Washers (8), and two 5/16” Nylon Locknuts (3).
5.Slide the Leg Press Seat Frame (79) onto the indi- cated 5/16” x 2 1/2” Carriage Bolts (1) in the Stabilizer (5). Hand tighten two 5/16” Nylon Locknuts (3) onto the Carriage Bolts.
Attach the other end of the Leg Press Seat Frame
(79)to the Leg Press Upright (56) with two 5/16” x 2 3/4” Bolts (11), two 5/16” Washers (8), and two 5/16” Nylon Locknuts (3).
Attach the Handle (82) to the Leg Press Seat Frame (79) with two 5/16” x 2 1/2” Carriage Bolts
(1) and two 5/16” Nylon Locknuts (3).
Tighten all 5/16” Nylon Locknuts (3) used in steps 1–5.
6.Set two Weight Bumpers (19) on the bracket on the Base (4) as shown. Set two Weight Bumpers on the bracket on the Stabilizer (5).
Stack eight Weights (25) onto each set of Weight Bumpers (19). Be sure that the pin grooves are on the indicated side of each stack of Weights.
Be careful not to tip either stack of Weights (25) until step 8 is complete.
7
4 | 11 |
| 75 |
55 |
| ||
|
| ||
|
|
| |
| 8 |
| 44 |
|
|
| |
27 |
|
|
|
3 |
|
|
|
|
| 44 | Crossbar |
11 |
| 3 |
|
|
|
| |
56 |
|
| 42 |
74 |
|
|
|
5 | 1 |
|
|
|
|
| |
|
|
| 79 |
| 11 |
|
|
56 |
|
| 3 |
8 |
|
|
|
3 | 3 |
|
|
|
| 82 | |
|
|
| |
| 1 | 5 | |
|
|
| |
6 | Pin |
|
|
| Grooves |
|
|
25 | 25 |
|
|
|
|
| |
| 5 |
|
|
19 |
|
| Pin |
Bracket |
|
| Grooves |
|
|
| |
Bracket |
| 19 | |
4 |
| ||
|
|
| |
