Weider WESY91080 manual Cable Assembly

16.Lubricate both axles (A) on the Top Frame (55).

Slide the Right Arm (48) onto the right axle. Note: Be careful not to confuse the Right and Left Arm.

Make sure the upper end of the Right Arm is behind the indicated bracket (B) on the Top Frame.

Tap two 1Ó Retainers (69) and a 1Ó Round Cover Cap (70) onto the right axle.

Make sure the teeth on the Retainers (69) bend toward the Cover Cap (70), as shown in the inset drawing.

Attach the Left Arm (47) in the same manner.

Press a 1 3/4Ó Square Inner Cap (44) into the lower end of each Arm (47) and (48).

Wet the lower end of each Arm with soapy water. Slide a 10Ó Pad (45) onto the lower end of each Arm.

17.Refer to the inset drawing. Attach the Bumper (82) to the Press Seat Frame (77) with the 1Ó Tap Screw (92).

Press a 2Ó Square Inner Cap (27) into each end of the Leg Press Arm (89).

Lubricate the 3/8Ó x 3 1/4Ó Bolt (85). Attach the Leg Press Arm (89) to the Press Base (51) with the Bolt and a 3/8Ó Nylon Locknut (21).

Cable Assembly

18.Locate and open the parts bag labeled ÒCable Assembly and Pulleys.Ó For Cable identification and routing during steps 18-35, refer to the Cable Diagram and Cable ID Chart on page 19.

Tighten the Bolt and Locknut on the pre-assembled Pulley (15) on the Top Frame (55)

Attach a ÒVÓ-Pulley (6) and a Long Cable Trap (50) to the indicated bracket (A) on the Butterfly Upright (42) with a 3/8Ó x 2 1/2Ó Bolt (7) and a 3/8Ó Nylon Locknut (21). Make sure the Long Cable Trap is positioned as shown, so it will hold the Cable in place.

16	55
	47
	B
A
	69
	70
48	44
45
	Axle
	69
	70
17
89
27	92
21	82
	77
85 Lubricate	77
27
51
18	7
	50
55	6
	A
15	21
42

10