Frame Assembly
1.Before beginning, be sure that you have read and understood the information on page 4.
Locate and open the parts bag labeled ÒFRAME ASSEMBLY.Ó
Press a 2Ó Square Cover Cap (78) onto each end of the Stabilizer (5).
Insert two 3/8Ó x 2 3/4Ó Carriage Bolts (94) up through the Stabilizer (5) and place it flat on the floor.
2.Press a 2Ó Square Inner Cap (27) into the end of the Butterfly Base (4).
Insert two 5/16Ó x 2 1/2Ó Carriage Bolts (1) up through the Butterfly Base. Secure the Carriage Bolts with pieces of tape (A) to prevent them from falling out.
Place the Butterfly Base (4) on the floor with the holes in the mounting bracket over the Carriage Bolts in the Stabilizer (5).
3.Insert four 5/16Ó x 2 1/2Ó Carriage Bolts (1) up through the Press Base (51) and secure them with tape.
Place the Press Base (51) on the floor with the holes in the mounting bracket over the Carriage Bolts in the Stabilizer (5).
Note: The mounting bracket on the Press Base (51) should be on top of the mounting bracket on the Butterfly Base (4).
4.Insert two 3/8Ó x 2 3/4Ó Bolts (93) through the holes in the two mounting brackets and the Stabilizer (5).
Hand tighten four 3/8Ó Nylon Locknuts (21) onto the four Bolts in the mounting brackets and Stabilizer.
Do not tighten the Nylon Locknuts yet.
1 |
|
|
5 |
|
|
|
| 78 |
|
| 94 |
78 |
|
|
2 |
|
|
5 |
|
|
|
| 4 |
| 1 |
|
| A | 27 |
3 |
|
|
| 51 |
|
1 |
|
|
| 1 |
|
|
| 4 |
|
| 5 |
4 |
|
|
93 | 21 |
|
|
| |
|
| 21 |
| 5 |
|
5
