THERMA TRIM
MODEL TT HYDRONIC BASEBOARD
ASSEMBLY INSTRUCTIONS
Position back panels
Back panels must be positioned correctly to accommodate accessories, as shown below.
Min 3 ¾" | Min 1Z\v" |
Max 4 ½" | Max 1>zn" |
Min 3" | Min 0" |
Max 3Z\v" | Max 2 Zx " |
Butt back panels together.
Hinged | Inside | Splice | Outside | Inside | Plain end cap |
end cap | bay corner |
| corner | corner | or wall end |
Attach back panel to wall
Screw or nail into wall studs at top and bottom.
No closer than 3 inches from end of panel.
Bottom of panel must never be lower than the surface of the finished floor or carpet.
Add shim as shown if necessary.
Shim (if needed)
Finished floor surface or carpeting.
Install brackets
Position brackets evenly along length of panel, approximately every 2 feet.
aInsert top bracket tab into top slot in back panel.
bPress bracket flat against back panel and slide down so bottom tab enters bottom slot in back panel.
Cut element
When a shorter length is needed
a | Measure from the |
New | female end for the |
length | required length. |
b | Cut glide rails with |
| tin snips. |
c | Remove 6 fins on |
| each side of the |
| location to be cut. |
d | Cut copper using |
New | tube cutter and |
length | ream to remove |
| |
| burrs. |