Well Traveled Living 60255 manual Heatproof casing pipe Casing/ electric wire

Contact toll free customer service hotline to order approved replacement lamps and parts.

NOTE: do NOT touch the new halogen lamp with your bare fingers.Oils from your hand could reduce the life of the lamp by causing a heat spot.Recommend using clean cotton or plastic gloves.A clean paper towel may also work.

Quartz Halogen Lamp Replacement:

*Be sure unit is unplugged from wall outlet!

*Remove 2 screws from each end of the head unit as shown in the figure as step 1 and 2 Remove 4 bolts from the front glass plate as shown in step 3

*Pull out & remove the left & right, front air vent panels and protective glass plate.(see #3)

-Note position of end clips on vent panel. They must be aligned as close to end

connectors of lamp tube as possible when re-assembled. Pull out and/or pushed into place.

*Gently pull out entire old lamp assembly from the clips at the terminal connection ends.

(see #4 & #5). Slide and lift the connection ends out from the friction clips by gently pushing apart the clips. Unscrew wire leads from terminal. Remove entire old lamp assembly.

*Gently re-insert connection ends of the NEW lamp assembly into the friction clips(see #4). Pull apart the clips slightly and gently push the connectors into place. Do not allow the

metal clips to touch the actual lamp tube. The clips should be about at the center point of the end connectors.

*Reconnect the wire leads to terminal connectors Re-insert vent panels by gently

pushing the end clips into housing body, align clip ends close to lamp end connectors and push into place. Insert the 2 screws in each end of the head unit (#1 and #2)

Replace front glass plate ,for best results,insert the 2 bolts for the top of the glass plate first,then insert the 2 bolts for the bottom of the glass plate Do not tighten until all four bolts are inserted

Do NOT over tighten a gap between the glass and steel housing in necessary for heat venting

Clip ends must be aligned as close to end connectors of lamp

tube when installed. Do NOT allow to touch tube lamp itself.

Heatproof casing pipe

a casing/ electric wire

Connecting wire	Gently re-insert connector
lead
	ends of the NEW lamp
Metal friction clips	assembly into the friction
Push apart sligtly	clips (see #4). Pull apart the
to remove	clips slightly and gently push
lamp tube end
connectors	the connectors into place. Do
	not allow the metal clips to
4 small	touch the actual lamp tube.
bolts	The clips should be about at
	the center point of the end
	connectors when
	re-assembled.

Remove & Replace ENTIRE Lamp assembly

including lamp, end connectors & wire lead

NOTE: do NOT allow any metal to contact actual lamp tube