Wells RWN-1 thru RWN-3 Narrow Installation, Risk of personal injury, Unpacking & Inspection

INSTALLATION

NOTE: DO NOT discard the carton or other packing materials until you have inspected the appliance for hidden damage and tested it for proper operation.

Refer to SHIPPING DAMAGE CLAIM PROCEDURE on the inside front cover of this manual.

WARNING:

Risk of personal injury

Installation procedures must be performed by a qualified technician with full knowledge of all applicable electrical and plumbing codes. Failure can result in personal injury and property damage.

UNPACKING & INSPECTION

Carefully remove the appliance from the carton. Remove all protective plastic film, packing materials and accessories from the Appliance before connecting electrical power or otherwise performing any installation procedure.

Carefully read all instructions in this manual and the Installation Instruction Sheet packed with the appliance before starting any installation.

Read and understand all labels and diagrams attached to the appliance.

Carefully account for all components and accessories before discarding packing materials. Store all accessories in a convenient place for later use.

COMPONENTS

1 - 4 ea. DRAWERS (qty. depends on model)

1 - 4 ea. HUMITROL RACKS (if ordered with unit)

SETUP

Setup the appliance only on a firm, level, non-combustible surface. Verify local codes for requirements. Concrete, tile, terrazzo or metal surfaces are recommended. Metal over combustible material may not meet code for non-combustible surfaces.

Install adjustable legs or optional casters, one on each corner of the appliance, in the holes provided.

Verify that the unit sits firmly ON ALL FOUR LEGS. With a spirit level, check that the appliance is level front-to-back and side-to-side. With the adjustable legs, adjust as required to level the appliance. All four legs must be adjusted to firmly contact the floor in order to prevent tipping.

If drawers were removed during installation, install drawer(s) in unit:

a.Check the roller catch inside the cabinet. The spring-loaded roller arm must be extended.

b.With the front of the drawer assembly tipped downward, engage the roller on the drawer with the cabinet drawer slide.

c.Raise the drawer to the horizontal position until the drawer- mounted slide engages the dual roller assembly on the cabinet.

d.Slide the drawer in until the catch engages. The drawer should remain tightly closed.

e.Slide the drawer out. The drawer stop should prevent the drawer from coming all of the way out.

f.Install drawer insert pans.

Avoid storing flammable or combustible materials in, on or near the appliance.

4