Wells BMW-206RTD, SS-10ULTD Agency Listing Information, Shock Hazard, Risk Of Damage, Hot Surface

Models: BMW-206RTD MOD-427TDMAF SS-10ULTD

1 16
Download 16 pages 26.85 Kb
Page 5
Image 5
SHOCK HAZARD

-In T’Stat Warmers

This appliance is intended for use in commercial establishments only.

This appliance is intended to hold pre-heated food for human consumption. No other use is recommended or authorized by the manufacturer or its agents.

Operators of this appliance must be familiar with the appliance use, limitations and associated restrictions. Operating instructions must be read and understood by all persons using or installing this appliance.

Cleanliness of this appliance is essential to good sanitation. Read and follow all included cleaning instructions and schedules to ensure the safety of the food product.

Disconnect this appliance from electrical power before performing any maintenance or servicing.

This appliance is not jet stream approved. Do not direct water jet or steam jet at this appliance, or at any control panel or wiring. Do not splash or pour water on, in or over any controls, control panel or wiring.

Exposed surfaces of this appliance can be hot to the touch and may cause burns.

Do not operate this appliance if the control panel is damaged. Call your Authorized Wells Service Agent for service.

The technical content of this manual, including any wiring diagrams, schematics, parts breakdown illustrations and/or adjustment procedures, is intended for use by qualified technical personnel.

Any procedure which requires the use of tools must be performed by a qualified technician.

This manual is considered to be a permanent part of the appliance. This manual and all supplied instructions, diagrams, schematics, parts breakdown illustrations, notices and labels must remain with the appliance if it is sold or moved to another location.

This appliance is made in the USA. Unless otherwise noted, this appliance has American sizes on all hardware.

WARNING:

SHOCK HAZARD

All servicing requiring access to non-insulated electrical components must be performed by a factory authorized technician.

DO NOT open any access panel which requires the use of tools. Failure to

follow this warning can result in severe electrical shock.

CAUTION:

RISK OF

RISK OFHOT SURFACEDAMAGE

DO NOT connect or energize this appliance until all installation instructions are read and followed. Damage to the appliance may result if these instructions are not followed.

CAUTION:

HOT SURFACE

Exposed surfaces can be hot to the touch and may cause burns.

for Built

AGENCY LISTING INFORMATION

011 303308 OpManual

Refer to the product nameplate for the specific appliance for agency listings. In general:

This appliance conforms to NSF Standard 4 for sanitation only if installed in accordance with the supplied Installation Instructions.

UL Listed warmers are UListed under UL File E6070.

Underwriters Laboratory recognized (AGENCY LISTING INFORMATION ) warmers (UL File E6070) - Since the warmer is only a single component of a complete installation,

the finished installation of an Manual background unit requires additional evaluations to Underwriters Laboratory standards.

STD 4

E6070

UL Listed Warmers

E6070

UL Recognized Warmers

3

Page 5
Image 5
Wells BMW-206RTD, SS-10ULTD, MOD-427TDMAF Agency Listing Information, Shock Hazard, Risk Of Damage, Hot Surface