1 Insert the key fully into the power switch.
Note: Inserting the key will not turn on the dis- plays. The displays will turn on when the
ON/RESET button is pressed or when the walking belt is started. If
you just installed batteries, the displays will already be on.
2 Reset the console and start the walking belt.
Slide the speed control down to the RESET position. Note: Each time the walking belt is stopped, the speed control must be moved to the RESET position before the walking belt can be restarted.
Next, slowly slide the speed control until the walking belt be-
gins to move at slow speed. Carefully step onto the walking belt and begin exercising. Change the speed of the walking belt as desired by moving the speed control.
To stop the walking belt, step onto the foot rails and slide the speed control to the RESET position.
3 Follow your progress with the four displays.
BURNING on page 14.) Every seven seconds, the display will change from one number to the other, as indicated by the mode arrows. This display also shows your pulse when the pulse sensor is used (see step 4).
The displays can be reset, if desired, by pressing the ON/RESET button.
4 Measure your pulse, if desired.
To measure your pulse, stand on the foot rails and place your thumb on the pulse sensor as shown. The pulse sensor is pressure ac-
down. Do not press too hard, or the cir- culation in your thumb will be re- stricted, and your pulse will not be de-
tected. Next, raise your thumb slightly until the
TIME
DISTANCE display— This display shows the distance that you have walked or run, in miles.
SPEED
CALORIES/FAT
CALORIES/PULSE
Mode Arrows
If the displayed pulse appears to be too high or too low, or if your pulse is not displayed, lift your thumb off the sensor and allow the display to reset. Press down again on the sensor as described above. Make sure that your thumb is positioned as shown, and that you are applying the proper amount of pressure to the pulse sensor. Try the sensor several times until you become familiar with it. Remember to stand still while measuring your pulse.
5 Adjust the incline of the tread- mill as desired.
To change the incline, press the top or bottom of the incline con- trol until the desired incline level is reached.
6 Turn off the power.
To turn off the power, simply wait for about four minutes. If the walking belt is stationary and the console buttons are not pressed for four minutes,
9
