TROUBLESHOOTING
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and | ||
follow the steps listed. If further assistance is needed, please see the front cover of this manual. | ||
PROBLEM: The power does not turn on |
|
|
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor | ||
is plugged into a properly grounded outlet (see page 11). Use only a | ||
sor that meets all of the specifications described on page 11. Important: The treadmill is not com- | ||
patible with |
|
|
b. After the power cord has been plugged in, make sure that the key is inserted into the console. | ||
c. Check the reset/off circuit breaker located on the | c |
|
treadmill frame near the power cord. If the switch |
| |
protrudes as shown, the circuit breaker has |
|
|
tripped. To reset the circuit breaker, wait for five | Tripped | Reset |
minutes, and then press the switch back in. | ||
PROBLEM: The power turns off during use |
|
|
|
|
|
SOLUTION: a. Check the reset/off circuit breaker located on the treadmill near the power cord (see c. above). If | |||||
the circuit breaker has tripped, wait for five minutes and then press the switch back in. |
| ||||
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for | |||||
five minutes, and then plug it back in. |
|
|
|
|
|
c. Remove the key from the console. Reinsert the key into the console. |
|
|
| ||
d. If the treadmill still will not run, see the front cover of this manual. |
|
|
|
| |
PROBLEM: The displays of the console do not function properly |
|
|
|
|
|
SOLUTION: a. Remove the key from the console and UNPLUG THE | a |
| 65 | 20 |
|
POWER CORD. Remove the five indicated M4.2 x | 25 |
| |||
10mm Screws (20) and the two M5.5 x 25mm Screws | 20 |
|
| 20 | |
(25). Then, carefully remove the Hood (65). |
| 25 |
| ||
|
|
|
|
| |
Locate the Reed Switch (97) and the Magnet (99) on |
|
|
|
|
|
the left side of the Pulley (95). Turn the Pulley until |
| 1/8 in. |
|
|
|
the Magnet is aligned with the Reed Switch. Make |
|
|
| 95 | |
sure that the gap between the Magnet and the |
| 97 |
|
| |
Reed Switch is about 1/8 in. (3 mm). If necessary, |
| 21 |
| 99 |
|
loosen the M4.2 x 13mm Screw (21), move the Reed |
|
|
| ||
Switch slightly, and then retighten the Screw. |
|
|
|
|
|
Reattach the Hood (not shown), and run the treadmill | Top View |
|
|
| |
for a few minutes to check for a correct speed read- |
|
|
| ||
ing. |
|
|
|
|
|
18
