2. While another person lifts the back of the Frame (1), attach the Rear Stabilizer (28) to the Frame with two M10 x 72mm Carriage Bolts (34) and two M10 Nylon Locknuts (33).
3. The Console (23) requires three “AA” batteries (not included); alkaline batteries are recommended. Insert three batteries into the battery compartment. Make sure that the batteries are oriented as shown by the diagram inside the battery compartment.
4. While another person holds the Console (23) near the Upright (2), connect the console wire to the Upper Wire (44). Next, attach the ground wire to the Upright with an M4 x 16mm Screw (42). Insert the console wire and the Upper Wire into the Upright, and insert the ground wire into the Console.
Next, attach the Console (23) to the Upright (2) with four M4 x 16mm Screws (42). Be careful to avoid pinching the console wire, the ground wire, or the Upper Wire (44).
Turn the Resistance Knob (63) counterclockwise to the lowest setting before going to the next step.
5. While another person holds the Upright (2) near the Frame (1), connect the Upper Wire (44) to the Reed Switch Wire (53). Next, connect the Resistance Cable
(63) to the Lower Cable (55) in the following way:
• See drawing A. Pull up on the metal bracket on the Lower Cable (55), and insert the tip of the Resistance Cable (63) into the wire clip inside of the metal bracket.
• See drawing B. Firmly pull the Resistance Cable (63) and slide it into the metal bracket on the Lower Cable (55) as shown.
• See drawing C. Using pliers, squeeze together the prongs on the upper end of the metal bracket.
Push the excess cable and wire down into the Frame
(1). Next, slide the Upright (2) onto the Frame. Be careful not to pinch the wires or cables. Attach the Upright with two M10 x 66mm Button Bolts (48), two M10 Split Washers (59), and two M10 Nylon Locknuts (33). Do not tighten the Button Bolts yet.
5
2 |
|
|
|
| 33 | 28 |
|
|
|
|
| ||
|
| 33 | 1 |
|
|
|
3 |
|
|
|
|
| 34 |
|
|
|
| Batteries | ||
|
|
|
|
| ||
|
| 23 |
|
|
|
|
4 |
|
|
|
| 23 |
|
|
|
|
|
|
| |
| Console Wire |
|
|
| ||
|
|
| 44 |
| 42 |
|
|
|
|
| 2 | Ground Wire | |
|
| 42 |
| 63 |
| |
|
|
|
|
|
| |
5 | 33 | 2 | 59 | 48 | Make sure that | |
|
|
|
| the wires and | ||
|
| 63 | 44 |
| cables do not | |
|
|
| get pinched | |||
|
| 55 | 53 |
| and damaged | |
|
|
| during this | |||
|
|
| 1 |
|
| step. |
|
|
|
|
|
| |
AMetal | B |
| C | 63 | ||
Bracket | 63 |
|
|
| ||
| 63 |
|
|
|
| |
|
|
|
|
| 55 | |
| 55 | 55 |
|
| ||
