ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
Assembly requires the included allen wrenches | and your own phillips screwdriver |
| |
wire cutters | , rubber mallet | , and adjustable wrench | . |
For help identifying the assembly hardware, refer to the drawings below. Note: The assembly hardware and other small parts are packaged in separate part bags. Do not open the part bags until instructed to do so. (The part bags are not labeled according to the order in which they are to be opened.) If a part is not found in the part bags, check to see if the part has been preassembled.
3/4” Screw | 1 1/4” Screw | 2” Silver Screw | |
1 1/4” Bolt |
| Wheel Bolt | |
1” Bolt | Wheel Nut | Internal Star | 5/16” Star |
| |||
|
| Washer | Washer |
1. Open part bag B. Identify the Right Upright (82) (the | 1 |
| |
Left Upright [69] has a large round hole in the location |
| ||
|
| ||
shown). Lay the Right Upright flat. Cut the plastic ties off |
| 83 | |
the lower end of the Right Upright. Next, feed the Wire |
| 82 | |
Harness (83) into the bottom of the Right Upright and |
| ||
pull it out of the hole in the top. Note: There may be a tie |
| 69 | |
on the end of the Wire Harness to help you pull it |
| ||
|
| ||
through the hole. |
|
| |
Attach the Right Upright (82) to the bracket on the right |
| Bracket | |
side of the Base (109) with two 1 1/4” Bolts (104) and |
|
| |
two Internal Star Washers (72). (Note: It may be helpful | Hole | 72 | |
to use a rubber mallet to fully insert the Right Upright | |||
| 104 | ||
into the bracket.) Do not tighten the Bolts yet. Be |
| ||
careful not to damage the Wire Harness. |
|
| |
Attach the Left Upright (69) to the left side of the |
| 109 | |
|
| ||
Base (109) in the same way. Note: There is not a wire |
|
| |
harness on the left side. |
|
|
6
