Weslo Cadence 80 user manual Hold the Console Assembly 91 near the Right

3. Have a second person lift and hold the front end	3
of the Frame (51). Hold a Frame Spacer (11) be-
tween the Right Upright (54) and the Frame.			54
Attach the Right Upright to the Frame with a
Frame Pivot Bolt (1), an Upright Washer (14),
and an Upright Star Washer (9). Do not tighten
the Frame Pivot Bolt yet.			11
Repeat this step on the left side of the tread-			14
mill.
			1
			9
			51
4. Set the Console Assembly (91) face down on a	4
soft surface to avoid scratching the Console		22	10
Assembly. Set the Left Handrail (22) on the
Console as shown. Attach the Left Handrail with
two Console Screws (10).
Attach the Right Handrail (not shown) to the			10
other side of the Console Assembly (91) as
described above.
		91
5. Hold the Console Assembly (91) near the Right	5
Upright (54). Touch the Right Handrail (33) to
discharge any static.			Connector
Remove the wire from the end of the Wire		91
Harness (39). Insert the end of the Wire
Harness through the large holes in the bottom
and side of the Right Handrail (33) and through
the two looped plastic ties.
Then, press the end of the Wire Harness (39) into	33
the connector on the back of the Console
			39
Assembly (91) in the location shown. See the
inset drawing. The end of the Wire Harness
should slide easily into the connector and			Plastic
snap into place. If it does not, turn the end of the	39		Ties
Wire Harness and then insert it. IF THE CON-
NECTOR IS NOT INSERTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.	54		Connector
			39
Insert the excess Wire Harness (39) downward
into the Right Upright (54). Tighten the two plas-
tic ties around the Wire Harness, and then cut off
the ends of the plastic ties.
	8