DIAGRAM OF THE CONSOLE | Monitor Display | Incline Control |
Speed Control |
Clip | Key | Pulse Sensor |
CAUTION: Before operating the console, read the following precautions.
¥Do not stand on the walking belt when turning on the power.
¥Always wear the clip (see the drawing above) while operating the treadmill. When the key is removed from the console, the walking belt will stop.
BATTERY INSTALLATION
The console requires two "AA" batteries (not in- cluded). Alkaline batteries are recommended. To in- stall batteries, first touch the Handrail (2) to dis- charge any static. Next, open the battery cover as shown below. Press two batteries into the battery com- partment, with the negative (Ð) ends of the batteries touching the springs. Close the battery cover, push up on the tab, and then push the tab forward as shown. Be sure that the tab locks into place.
|
| Battery Cover |
Batteries |
| Battery |
| 2 | Cover Tab |
8 |
| |
|
|
¥Adjust the speed in small increments.
¥The training zones marked around the speed control are general guidelines only. See page 14 or more information.
¥To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console and use only a sealable water bottle.
STEP BY STEP CONSOLE OPERATION
Step onto the foot rails of the treadmill. Find the clip attached to the key (see the drawing above), and slide the clip onto the waistband of your clothing. Follow the steps below and on page 9 to operate the console.
1Insert the key fully into the power switch.
Note: Inserting the key
will not turn on the dis- plays. The displays will
turn on when the ON/RESET button is
pressed or when the walking belt is started.
(If you just installed
batteries, the displays will already be on.)
