Weslo WATL16105.0 user manual Assembly, Do not tighten the Handrail Bolts yet

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not remove the long wire inside of the right handrail yet. In addition, do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex key and your own phillips screwdriver , adjustable

spanner , and wire cutters .

Note: To identify small parts used during assembly, see the PART IDENTIFICATION CHART in the center of this manual. Some parts may be preassembled.

1.Attach the six Base Pads (19) to the bottom of the Base (71) with six Base Pad Screws (42).

2.Have a second person hold the Base (71) in the position shown.

Identify the Right Handrail (6), which has a large hole near the lower end. Hold the Right Handrail so the bend is in the position shown. Attach the Right Handrail to the Base (71) with two Handrail Bolts (12) and two Nuts (17).

Do not tighten the Handrail Bolts yet.

Attach the Left Handrail (7) to the Base (71) in the same way.

1
	71	42
42		19	42
19
			19
42
19	42
	19
2
			Bend
7
		6
71	12
		Large
		Hole
17	12

6