Weslo WLAW55072 user manual Tighten all parts used in steps 1

2.Refer to figure 2b. Slide a Finger Guard (54) onto the Hex Bushing (33) and the pin on the Left Pivot Bracket (7). Note: The Finger Guard may already be attached.

Refer to figure 2a. Find the Left Link Arm (11), which is labeled with a sticker. Make sure that there are two 3/8Ó Bushings (16) in each end of the Link Arm. Using a rubber mallet, tap one end of the Link Arm onto the pin on the Left Pivot Bracket (7).

Make sure that the Link Arm is turned as shown in figure 2c. Tap a 3/8Ó Axle Cap (40) onto the pin.

Tap the other end of the Left Link Arm (11) onto the pin on the Rocker Arm (9). This will be a tight fit. (Note: If necessary, pivot the Rocker Arm and the Left Leg [3].) Tap a 3/8Ó Axle Cap (40) onto the pin.

Attach the other Finger Guard and the Right Link Arm in the same manner (not shown).

3.Rest the Right Frame Section (6) on the floor and hold it in the position shown.

Slide the Hip Pad (28) onto the Left Frame Section (5). Slide the Left Frame Section onto the Right Frame Section (6). Make sure to slide both ends on at the same time. Use the rubber mallet, if necessary, to make sure that the Left Frame Section is fully seated on the Right Frame Section.

Tighten two M5 x 16mm Screws (23) into the Left and Right Frame Sections (5, 6).

Slide the Hip Pad (28) so it is centered on the Left and Right Frame Sections (5, 6).

4.Refer to figure 4a. Position the Left and Right Frame Sections (5, 6) around the Left and Right Uprights (1, 2) as shown. Note: It will be neces- sary to turn the Frame Sections at an angle in order to slide them over the Uprights.

Refer to figure 4b. Attach the Left Frame Section

(5) to the Left Upright (1) with an M10 x 138mm Bolt (42), a Plastic Spacer (41), and an M10 Nylon Locknut (43). Do not tighten the Nylon Locknut yet. Attach the Right Frame Section (6) to the Right Upright (2) in the same manner.

Tighten all parts used in steps 1 and 4.

Fig. 2a	7
		Pin
		16
	40	11
	3	Fig. 2b			7
9		54		33 Pin
		Fig. 2c	Long
			Side
Pin
	16			Pin	7
	40		11
Fig. 3
			5
23
			28
		23
	6
Fig. 4a	6
	2
5
	Fig. 4b
		5			6
1				43
					2
	42			41
		1

6