Weslo WLAW55072 user manual

5.Turn the Pedal Covers (27) upside-down. Remove the paper backing from the adhesive strips on the bottoms of the Pedal Covers.

Center one Pedal Cover (27) on the lower end of the Left Leg (3). Press the Pedal Cover firmly into place.

Attach the other Pedal Cover (27) to the lower end of the Right Leg (4) in the same manner.

6.Note: Your Electronic Monitor (37) may look different from the one shown in this manual, but operates in exactly the same way. If your Monitor has a battery cover (see figure 6), install batteries as described in this step. If your Monitor does not have a battery cover, see step 7 to install batteries. Note: Two ÒAAÓ batteries (not included) are required. Alkaline batteries are recommended.

Press the tab on the battery cover and remove the battery cover. Insert two batteries into the Elec- tronic Monitor (37). Make sure that the batteries are turned as shown. Replace the battery cover.

7.Refer to figure 7a. Remove the two M4 x 16mm Screws (48) from the monitor bracket and the Electronic Monitor (37). Lift the Monitor off the monitor bracket. Be careful not to pull the wire.

Refer to figure 7b. Insert two batteries into the back of the Electronic Monitor (37). Make sure that the batteries are turned as shown.

Refer to figure 7a. Reattach the Electronic Monitor

(37)to the monitor bracket with the two M4 x 16mm Screws (48).

8.Remove the two indicated M4 x 16mm Screws

(48)from the Right Upright (2). Attach the monitor bracket to the Right Upright with the two Screws. Note: If the Electronic Monitor (37) does not operate properly, see HOW TO ADJUST THE REED SWITCH on page 11.

Fig. 5	27
	27

4

3

Fig. 6

Note: Your Monitor may look different from the one

37 shown in this manual, but operates in exactly the same way.

Battery Cover

Fig. 7a Fig. 7b

37

48

Wire

37

Monitor

Bracket

Fig. 8

37

48 Monitor Bracket

2

7