Weslo WLCR96058 Maintenance and TROUBLE-SHOOTING, HOW to Replace the Batteries, Reed Switch

MAINTENANCE AND TROUBLE-SHOOTING

Inspect and tighten all parts of the CARDIO GLIDE PLUS at least once every three months. Make sure that the Foam Pad (26) is pushed all of the way onto the axle at the front. The CARDIO GLIDE PLUS can be cleaned with a soft, damp cloth. Keep liquids away from the monitor. Do not expose the monitor to direct sunlight or the display may be damaged. When storing the CARDIO GLIDE PLUS, remove the batteries from the monitor.

HOW TO REPLACE THE BATTERIES

26

If the display of the Monitor (1) becomes dim, the two “AA” batteries should be replaced. Lift the Monitor off the Frame

(6). Disconnect the Sensor Wire (15) from the Monitor. Make sure that the end of the Sensor Wire does not slip into the Frame. Remove the two old batteries from the battery clip inside the back of the Monitor. Insert two new batteries.

Connect the Sensor Wire (15) to the wire on the Monitor (1). Insert all excess wire into the Frame (6). Press the Monitor onto the Frame (see assembly step 5 on page 5).

HOW TO ADJUST THE MAGNET AND REED SWITCH

If the monitor displays incorrect feedback, the Magnet (27) and Reed Switch (15) should be checked. Pivot the Pedal Frame (32) until the Magnet is aligned with the Reed Switch. Loosen the #8 x 3/4” Screw (18) shown in the inset drawing. Slide the Reed Switch slightly closer to the Magnet. Tighten the #8 x 3/4” Screw. Exercise on the CARDIO GLIDE PLUS for a moment. Repeat until the monitor displays correct feedback. Make sure that the Magnet does not hit the

Reed Switch.

HOW TO LUBRICATE THE CARDIO GLIDE PLUS

Every three months, a small amount of light multi-purpose oil should be applied to the CARDIO GLIDE PLUS. Apply a few drops of oil between the dome caps and the frame in the locations shown at the right. Make sure to apply oil to both sides of the CARDIO GLIDE PLUS.

1
	Batteries
15
6	1	Clip

	32	27	15
		15
		18
32	27

Apply Oil

8