ASSEMBLY

Place all parts of the CARDIO GLIDE PLUS in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Read each step carefully before beginning. THE

FOLLOWING TOOLS ARE REQUIRED FOR ASSEMBLY: The included pedal tool , and your own

phillips screwdriver and rubber mallet .

1. Raise the Handlebar Frame (7) to the position shown.

1

 

Hold the Handle (20) and hook the Link Arms (4) onto

 

 

 

the lower Rollers (33) on the Handlebar Frame.

 

7

Tap two Round Endcaps (8) onto the stabilizer at the

 

 

front of the Frame (6). Tap two Round Endcaps onto

 

33

the stabilizer at the rear of the Frame (not shown).

 

 

4

 

 

 

 

20

 

 

8

 

 

6

2. Turn the Seat Knob (38) to loosen it. Pull down the

2

 

Seat Knob and slide the Seat (3) onto the Seat Frame

 

 

5

(5). Slide the Seat to the desired position and release

 

 

 

the Seat Knob. Retighten the Seat Knob. Push on the

 

3

Seat to make sure that the Seat Knob is engaged in

 

 

one of the holes in the underside of the Seat

 

 

Frame.

 

 

 

 

38

3. Press the two Domed Endcaps (13) onto the upper

3

 

end of the Handlebar Frame (7).

2

 

Insert the Handlebar (2) into the Handlebar Frame (7).

 

 

The sides of the Handlebar must bend toward the seat

 

13

(not shown). Tighten the four #8 x 1/2” Screws (16)

 

 

into the Handlebar Frame and the Handlebar.

 

 

 

 

7

 

 

16

4. The Monitor (1) requires two “AA” batteries (not

4

Batteries

included); alkaline batteries are recommended.

 

Insert two “AA” batteries into the battery clip inside the

 

 

back of the Monitor. Make sure that the negative (-)

 

 

ends of the batteries are touching the springs in the

 

 

battery clip.

 

 

 

 

1

4

 

Clip

 

 

Page 4
Image 4
Weslo WLCR96058 user manual Assembly, Monitor 1 requires two AA batteries not, Included alkaline batteries are recommended