Turbo Chef Technologies Residential Single and Double Wall Oven service manual Removing the Oven

A.6 APPENDIX - REPLACING OVEN COMPONENTS

Component and Assembly Location, DWO Gen 1 and Gen 2

DANGER: Before removing or replacing any oven component, ensure the oven is removed from any power source (i.e., the breaker is turned off). Failure to do so can result in serious injury or death.

WARNING: Before removing or replacing any oven component, thoroughly read the safety instructions found at the front of this manual and in Oven Systems (Section 5) and Troubleshooting (Section 6). Adhere to all precautions and warnings outlined in these sections, as failure to do so could result in serious injury or death.

CAUTION: Before removing/installing any component, make sure it is disconnected from the wire harness (where applicable).

Removing the Oven

In order to remove the oven from the wall, the two mounting screws (P/N: 104184), located on the inside of the Speedcook oven’s outer trim, must be removed (additionally, some older DWO oven models have 2 cabinet screws in the lower oven’s outer trim). The oven may be safely pulled away from the wall approximately 11” (280 mm) to remove the front top cover, lower EC access panel, and the door switch covers. Any further removal requires the oven to be fully removed from the wall and placed upon a cart capable of supporting approximately 410 lbs (186 kg).

Item Description	Item Part #	Hardware Description	Hardware Part Number(s)
Cable, Display, L.V., DWO	RWD-9427	None	None
Cable, Ribbon, 6”	104208	None	None
Cover, Back, DWO	RWD-9184	Screw, SH MTL, #8 x 1/2 Serrated PHTRH	101688 (x19)
Diverter, Vent Outlet	RWD-9584	None	None
Door Sensing Switch	104229	Screw, SH MTL, #8 x 1/2 Serrated PHTRH	101688 (x3)
Door Skin, Replacement	RWD-3004-X	None	None
Door, Lower	RWD-3021	None	None
		Screw, SH MTL, #8 x 1/2 Serrated PHTRH	101688 (x4)
Door, Speedcook Oven	RWD-3019-X	Cover, Hinge Pocket	RWD-9472 (x2)
		Screw, #8-32 x 3/8, PPH, THD-Forming, PLT	104227 (x2)
Door, Speedcook Oven, Inner	RWD-3022	None	None
Electrical Compartment, Lower,	N/A	None	None
Gen 1 (see pages A.22-A.23)
Electrical Compartment, Lower,	N/A	None	None
Gen 2 (see pages A.22-A.23)
Electrical Compartment, Upper,	N/A	None	None
Gen 1 (see pages A.13-A.15)
Electrical Compartment, Upper,	N/A	None	None
Gen 2 (see pages A.16-A.17)
Front Trim, DWO		Screw, #8 x 3/8 PH MOD TRUSS CRES	101682 (x16)
	N/A	Screw, SH MTL, #8 x 1/2 Serrated PHTRH	101688 (x4)
(see pages A.10-A.11)
		Screw, #8 x 2.00 PH MOD TRUSS SS	104184 (x2)
Handle, Lower Oven	RWD-9224	Bolt, Handle, Lower Oven	RWD-9457 (x2)
Handle, Speedcook Oven	RWD-9011	Bolt, Handle, Speedcook Oven	RWD-9458 (x2)
Harness, Failsafe, Microwave	RWD-9555	None	None
Harness, Fuse, Cooling Fan	RWD-9553	None	None
Oven, Lower	N/A	None	None
(see pages A.28-A.29)