A.10 APPENDIX - REPLACING OVEN COMPONENTS
Front Trim Assembly Detail
DANGER: Before removing or replacing any oven component, ensure the oven is removed from any power source (i.e., the breaker is turned off). Failure to do so can result in serious injury or death.
WARNING: Before removing or replacing any oven component, thoroughly read the safety instructions found at the front of this manual and in Oven Systems (Section 5) and Troubleshooting (Section 6). Adhere to all precautions and warnings outlined in these sections, as failure to do so could result in serious injury or death.
CAUTION: Before removing/installing any component, make sure it is disconnected from the wire harness (where applicable).
Front Trim Assembly Removal
WARNING: When removing the front trim assembly, ensure that the surrounding floor and cabinetry are protected from damage.
WARNING: Failure to properly reconnect the wiring harness will result in damage to critical oven components. Carefully note the orientation and location of every wire connection.
1.Remove the oven door(s) (see pages
2.Remove the 2 cabinet screws from the speedcook oven frame (additionally, some older DWO oven models have 2 cabinet screws in the lower oven frame).
3.Pull the oven from the wall approximately 11” (280 mm).
4.Remove the Front Top Cover and detach the USB port from the control board.
5.Detach the Control Housing Assembly from the Upper Electrical Compartment by removing the 2 screws from each of the Control Assembly Brackets.
6.Remove all screws securing the Front Trim Assembly to the oven’s frame.
7.Disconnect the wiring harness from the electrical components in the Control Housing Assembly.
8.Remove the Diverter, Vent Outlet from the bottom of the oven.
9.Disconnect the wiring harness from the lower oven control components (if applicable).
10.Remove the front frame and place in a secured location.
