Turbo Chef Technologies Residential Single and Double Wall Oven Bracket, USB, Strap RWS-9026

A.8 APPENDIX - REPLACING OVEN COMPONENTS

Component and Assembly Location, SWO

DANGER: Before removing or replacing any oven component, ensure the oven is removed from any power source (i.e., the breaker is turned off). Failure to do so can result in serious injury or death.

WARNING: Before removing or replacing any oven component, thoroughly read the safety instructions found at the front of this manual and in Oven Systems (Section 5) and Troubleshooting (Section 6). Adhere to all precautions and warnings outlined in these sections, as failure to do so could result in serious injury or death.

CAUTION: Before removing/installing any component, make sure it is disconnected from the wire harness (where applicable).

Removing the Oven

In order to remove the oven from the wall, the two mounting screws (P/N: 104184), located on the inside of the Speedcook oven’s outer trim, must be removed. The oven may be safely pulled away from the wall approximately 11” (280 mm) to remove the front top cover, lower EC access panel, and the door switch covers. Any further removal requires the oven to be fully removed from the wall and placed upon a cart capable of supporting approximately 230 lbs. (105 kg.).

Item Description	Item Part #	Hardware Description	Hardware Part Number(s)
Air Switch	102009	Screw, 4-40 x 5/8, PPH, SS	101550	(x2)
Blower, Exhaust	104190	Screw, SH MTL, #8 x 1/2 Serrated PHTRH	101688	(x2)
Cover, Back, SWO	RWS-9018	Screw, SH MTL, #8 x 1/2 Serrated PHTRH	101688	(x11)
Door Skin, Replacement	RWD-3004-X	None	None
		Screw, SH MTL, #8 x 1/2 Serrated PHTRH	101688	(x4)
Door, Speedcook Oven	RWD-3019-X	Cover, Hinge Pocket	RWD-9472 (x2)
		Screw, #8-32 x 3/8, PPH, THD-Forming, PLT	104227	(x2)
Door, Speedcook Oven, Inner	RWD-3022	None	None
Electrical Compartment, SWO	N/A	None	None
(see pages A.16-A.17)
Front Trim, SWO		Screw, #8 x 3/8 PH MOD TRUSS CRES	101682	(x16)
	N/A	Screw, SH MTL, #8 x 1/2 Serrated PHTRH	101688	(x4)
(see pages A.10-A.11)
		Screw, #8 x 2.00 PH MOD TRUSS SS	104184	(x2)
Handle, Speedcook Oven	RWD-9011	Bolt, Handle, Speedcook Oven	RWD-9458 (x2)
Harness, Single	RWS-9002	None	None
Oven, Speedcook, SWO	N/A	None	None
(see pages -A.25)
Thermostat, 270F, Open on Rise	104228	Screw, #6 x 1/2, PPHD, DRL-PT, SS	101687	(x2)
Top Cover, Front	RWD-9356	Screw, SH MTL, #8 x 1/2 Serrated PHTRH	101688	(x7)
Top Cover, Rear	RWD-9355	Screw, SH MTL, #8 x 1/2 Serrated PHTRH	101688	(x11)
USB Port, Gen 2	103193	Screw, SH MTL, #8 x 1/2 Serrated PHTRH	101688	(x2)
		Bracket, USB, Strap	RWS-9026