Weslo WLEL36070 user manual

4.Connect the Reed Switch Wire (3) to the Extension Wire (15).

Slide the Upright (2) onto the Frame (1); be careful not to pinch the Reed Switch Wire (3), the Extension Wire (15), or the Resistance Cable (17).

Attach the Upright with three M10 x 25mm Button Head Screws (25) and three Split Washers (69).

5.Attach the Upright Bracket (26) to the Upright (2) with two M6 x 1Ó Hex Head Screws (27) and two 1/4Ó Split Washers (62). The square hole must be on the left side.

Push the Handlebar Caps (28) onto the lower ends of the Handlebars (10, 11). Align the indicated holes and make sure that the frictions pads are on the side shown. See drawing 5a. Apply a thin film of grease to both sides of the Handlebar Caps.

Hold the lower end of the Left Handlebar (10) inside of the Upright Bracket (26). Insert the M10 x 150mm Carriage Bolt (32) into the Upright Bracket and through the Left Handlebar. Be careful not to dam- age the wires inside the Upright. Hold the Right Handlebar (11) inside of the Upright Bracket. Insert the Carriage Bolt until the head of the Carriage Bolt is in the square hole in the Upright Bracket. Slide the Star Washer (29) onto the Carriage Bolt and tighten the Resistance Knob (30) onto the Carriage Bolt.

See drawing 5b. Align the holes in the Handlebars (10, 11) with the hole in the Upright (2). Insert the Lock Pin (31) through the Handlebars and the Upright. Be care- ful not to damage the wires inside the Upright.

6.Connect the console wire to the Extension Wire (15). Insert the Extension Wire and the console wire into the Upright (2). Attach the Console to the Upright with four Console Screws (33).

7

4
		2
	69
	25	69	25
	15	17
	3
			1
5	5a
		28
		Grease
			11
	2
27		30
		29	Holes
	62
			Friction
10	26		Pad
			28
	32		5b
Holes			10
			11
	28		31
Friction
Pad			2
6			13
Console
Wire
15
			33
33		2