ASSEMBLY
Assembly requires two persons. Place all parts of the WESLO¨ ECLIPSE II in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included grease packet, a phillips screwdriver 
, two adjustable
wrenches 
, and a rubber mallet 
.
1.Remove the #8 x 3/4Ó Tec Screw (42) from the Cable Cover (53). While another person holds the Upright
(2) near the Base (1), carefully pull the Resistance Cable (33) up through the Upright until there is no slack between the Upright and the Base.
Next, insert the Extension Wire (49) into the Base (1) until there is no slack between the Upright and the Base.
Slide the Upright (2) onto the welded bolts on the Base (1). Be careful to avoid pinching the
Extension Wire (49) and the Resistance Cable (33). Tighten a 3/8Ó Nylon Locknut (54) onto each welded bolt.
Insert the upper end of the Resistance Cable (33) into the Upright (2) as shown. Insert the tab on the Cable Cover (53) into the slot in the Upright. Attach the Cable Cover to the Upright with the #8 x 3/4Ó Tec Screw (42).
2.Identify the Left Handlebar (6) and the left Extension Tube (5) (there are stickers on the Handlebars and Extension Tubes for identification). Make sure that there is a Tree Fastener (63) in the Extension Tube. If there is not, insert a Tree Fastener as shown.
Slide the Left Handlebar (6) onto the left Extension Tube (5), being careful not to damage the Tree Fastener (63). Align one of the three holes in the Left Handlebar with the hole in the Extension Tube and insert a Lock Pin (37) into the holes. Turn the Lock Pin to the position shown in drawing 2a.
Repeat this step to attach the Right Handlebar to the right Extension Tube (not shown).
1 |
|
|
|
| Slot |
33 |
| 53 |
|
| 42 |
| 2 |
|
|
| 54 |
|
| 33 |
| 1 | 49 |
|
| |
2 |
| 2a |
6 |
| 6 |
|
| |
37 |
| 37 |
|
| |
|
| 5 |
|
| 63 |
5
