6.Attach the Seat (12) to the Seat Carriage (4) with four M6 x 16mm Button Screws (57).
7.The Console (16) requires two AA batteries (not includ- ed). Alkaline batteries are recommended. Refer to the inset drawing. Remove the battery cover from the back of the Console, and insert two AA batteries into the Console. Make sure that the negative ends of the batteries (marked
Next, plug the Reed Switch Wire (43) into the back of the Console (16). Carefully slide the Console onto the indicated tab on the Frame (1). Note: The Console is held by friction; it does not snap into place.
Press the Resistance Knob (14) onto the Resistance Control (13).
8.Identify the Left Pedal (24), which is marked with an “L.” Using an adjustable wrench,firmly tighten the Left Pedal counterclockwise into the left arm of the Crank (27). Tighten the Right Pedal (not shown) clock- wise into the right arm of the Crank. Important:
Tighten both Pedals as firmly as possible. After using the exercise cycle for one week, retighten the Pedals. For best performance, the Pedals must be kept tightened.
Adjust the Left Pedal Strap (65) to the desired position and press the end of the Strap onto the tab on the Left Pedal (24). Adjust the Right Pedal Strap (not shown) in the same way.
6 |
|
|
12 |
|
|
57 |
|
|
4 | 57 |
|
| 57 |
|
7 | 16 |
|
|
| |
43 |
|
|
| 1 |
|
| 14 |
|
| 13 |
|
| Battery | 16 |
|
| |
| Cover |
|
| Batteries |
|
8 |
|
|
65 | 27 |
|
24 |
|
|
| Tab |
|
9.Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is completed, some extra hardware may be left over. Place a mat beneath the exercise cycle to protect the floor.
6
