HOW TO OPERATE THE CONSOLE
Note: If there is a thin sheet of clear plastic on the face of the console, remove it.
1.To turn on the power, press the mode button or begin pedaling. The entire display will appear for two seconds; the console will then be ready for use.
2.Select one of the five modes:
Scan mode—
When the
power is turned on, the scan mode will auto- matically be
selected. One mode indicator
will show that the scan mode
is selected, and a second mode indicator will show which mode is currently displayed. Note: If a differ- ent mode is selected, you can select the scan mode by repeatedly pressing the mode button.
Time, speed, distance, or
calories
for continuous display, press
the mode but-
ton repeatedly. The mode indicators will show which mode is selected. Make sure that the scan mode is not selected.
3.To reset the display, press the mode button for two seconds. After the display is reset, the scan mode will be selected.
4.To turn off the power, simply wait for about four minutes. The console has an
If the pedals are not moved and the mode but- ton is not pressed for four minutes, the power will turn off automatically to conserve the bat- teries.
MAINTENANCE AND TROUBLESHOOTING
Inspect and tighten all parts of the exercise cycle reg- ularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a small amount of mild soap. Important: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight.
BATTERY REPLACEMENT
If the console does not function properly, the batteries should be replaced. Refer to step 7 on page 6 for replacement instructions. In addition, make sure that the reed switch wire is plugged fully into the console. Note: The console requires two AA batteries; alkaline batteries are recommended.
8
