WINTER USE AND CARE
The hydrotherapy spa is designed for
1.Drain the spa (see DRAINING THE HYDROTHERAPY SPA on pages 16 and 17).
2.Remove all remaining water from the spa shell. Dry the spa shell with towels.
3.Set the air control on the console to the lowest setting. Use a wet/dry vacuum to pull any remain- ing water from the system. To do this, place the vacuum nozzle over each
4.Set the air control on the console to the highest setting and repeat step 3.
5.Drain the pump (see DRAINING THE PUMP on page 17). Once the water has drained from the pump, place the vacuum nozzle over the drainage hole in the pump and vacuum any addi- tional water from the pump. Note: For additional protection you can remove the pump/motor from the spa to store it in a climate controlled room.
6.Clean the spa shell (see page 15).
7.Clean the filter (see page 15).
8.A qualified electrician should disconnect the power cord from the 240 volt power source.
9.
CONVERTING THE SPA TO A 240 VOLT POWER SOURCE
The hydrotherapy spa is designed to operate with either a 120v or 240v power source. For your conve- nience, it is shipped ready to be plugged directly into a 120v/15 amp home outlet.
However, you can greatly improve the performance of the spa by converting the spaÕs power supply to receive power from a 240v power source. If the spa is converted, it must be wired directly into a 240v GFCI in your home by a qualified electrician.
You will need to call our Customer Service Department
WARNING: Only a qualified electrician should per- form the conversion procedure.
18
