CONVERTING THE SPA TO A 240 VOLT POWER SOURCE
The hydrotherapy spa is designed to operate with either a 120v or 240v power source. For your conve- nience, it is shipped ready to be plugged directly into a 120v/15 amp home outlet.
However, you can greatly improve the performance of the spa by converting the spaÕs power supply to receive power from a 240v power source. If the spa is converted, it must be wired directly into a 240v GFCI in your home by a qualified electrician.
You will need to call our Customer Service Department
WARNING: Only a qualified electrician should per- form the conversion procedure.
CHECKING AND CLEANING THE FILTER
The filter should be checked periodically for
Removing and Cleaning the Basket:
1.Turn off the power.
2.Pull the weir door towards you until it is fully open.
3.Reach into the basket with four fingers and pull the basket towards you until it snaps free.
4.Lift the basket out of the housing by pulling on the handle on the far side and turning the basket towards you.
5.Clean the basket by spraying it with a garden hose or holding it under a faucet. Note: Avoid hitting the basket against objects to clean it, since this may break the basket.
6.Put the basket back into the housing and press down until it snaps into place.
7.Close the weir door.
Removing and Cleaning the Filter Cartridges:
1.Follow steps one through four above to remove the basket.
2.Reach into the housing and turn the valve on the diverter until it is fully open.
3.Stick two fingers into the holes in the diverter and lift the diverter and the top filter cartridge directly upwards until the edge of the diverter clears the housing. Then turn the diverter towards you and pull it out. In this process, the diverter may come out of the filter cartridge. If so, reach into the housing and lift the filter cartridge out.
4.Lift the lower filter cartridge out of the housing.
5.Clean the filter cartridges with a garden hose or under a faucet. Spray from top to bottom of each pleat. Note: To avoid damage to the car- tridges, do not use a brush to clean them.
6.To remove body oils or sun tan lotions, soak the cartridges in a cleaning solution which can be obtained from a pool and spa supply store.
7.Inspect the filter cartridges for damage. Replace the cartridge if there is any sign of damage.
8.Put one filter cartridge back in the filter housing.
9.Push the tube on the diverter into the other filter cartridge as far as it will go. Place the top filter cartridge back in the housing.
10.Put the basket back into the housing and press down until it snaps into place. Close the weir door.
ADJUSTING THE FILTER DIVERTER
The diverter regulates the flow of water to the filter in order to make the pump run smoothly. Start by leav- ing the valve wide open. If the pump runs smoothly, no further adjustment will be necessary.
If the pump begins to cavitate (if you hear a cracking sound or if the speed of the pump surges up and down), turn the valve slightly to reduce water flow. Keep adjusting the valve in small increments until the pump runs smoothly.
18