SET-UP AND ASSEMBLY
Before beginning assembly, carefully read the following information and instructions:
¥Place all parts in a cleared area and remove the packing materials from the spa shell; do not dis- pose of the packing materials until assembly is completed and the spa is in operation.
¥Assembly requires two people.
¥During assembly, make sure that all parts are ori- ented as shown in the drawings.
¥Read each assembly step before you begin.
¥Tighten all parts as you assemble them, unless instructed to do otherwise.
ASSEMBLY REQUIRES THE FOLLOWING TOOLS (not included):
¥One (1) phillips screwdriver
¥You may also need some soap or wax.
1.Before beginning assembly, be sure that you have read and understand the information on the previous two pages.
Remove the four cover screws from the access cover. Remove the access cover from the Spa Unit
(15)by sliding the access cover down and pulling the bottom of the access cover away from the Spa Unit. Be careful not to damage the spa shell.
Remove the Power Cord with the GFCI (38) from inside the Spa Unit (15).
2.Locate and check the position of the
MOTOR WILL BE DAMAGED IF IT IS OPERATED WITH THE
Close the valve knob on the drain hose. Thread the cap onto the drain hose. Thread the drain plug into the Pump Motor (13). Tighten the pump fittings.
1 |
|
|
| |
| Spa |
|
| |
| Shell |
| 15 | |
|
|
| ||
|
|
| 38 | |
| Access | Access Cover | ||
| Cover | |||
|
| Screws | ||
|
|
| ||
2 |
|
| ||
|
| |||
Valve |
|
| ||
|
|
| 13 | |
|
|
| Drain Hose | |
Cap | Valve | Drain | Pump | |
Knob | Plug | Fittings | ||
|
8