Weslo WLTL11310.0 Assembly, Do not tighten the Nylon Nuts yet, Not tighten the Nylon Nuts yet

ASSEMBLY

To hire an authorized service technician to assemble the treadmill, call 1-800-445-2480. Assembly

requires only the included hex key and wrench .

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: Some small parts may have been pre-assembled. To avoid damaging parts, do not use power tools for assembly. Extra hardware may be included. The number in parentheses in the drawing below is the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses is the quantity needed for assembly.

M4 x 12mm	M5 x 10mm Bolt	M8 x 15mm Bolt
Screw (3)–2			M8 Curved	M8 Washer
	(10)–2	(33)–4
			Washer (37)–4	(34)–4
M8 Nylon	M8 x 50mm Bolt
Nut (13)–4		(38)–4

1. Identify the Right Upright (36), which has a single hole	1
in the indicated location. (Note: There is a wire inside of				Holes
the Left Upright [35].) Hold the Right Upright against the
Base (14) as shown, and orient the Right Upright so the			36
two indicated holes are on the side shown.	37				Hole
Attach the Right Upright (36) to the Base (14) with two				14
M8 x 50mm Bolts (38), two M8 Curved Washers (37),	38				Holes
and two M8 Nylon Nuts (13) as shown. Make sure that
the curved sides of the Washers are against the Base.		13			35
Do not tighten the Nylon Nuts yet.				37
Attach the Left Upright (35) to the Base (14) in the		37			13
same way. Make sure that the Left Upright is oriented
so the two indicated holes are on the side shown. Do		38
not tighten the Nylon Nuts yet.					37
2. Raise the Left Upright (35) and the Right Upright (36) to	2
the position shown.		35			36

6