Weslo WLTL19012 user manual Touch the Right Handrail to discharge any static

4.See inset drawing 4c. If there is a plastic tie in the square hole in the bottom of the Right Handrail (6), remove it.

Attach the Console Plate (4) to the Right and Left Handrails (6, 7) by pushing the Handrails inward and tightening two Console Bolts (9) and Handrail Washers (11) into the Console Plate and Handrails.

Hold the Console Base (1) near the Right Handrail (6).

Touch the Right Handrail to discharge any static.

Remove the tape from around the connectors at the end of the Wire Harness (22). Locate the two wires in the Wire Harness that have L-shaped connectors on the ends. Press the connectors onto the two tabs on the red switch indicated in inset drawing 4b. Connect the other two wires in the Wire Harness to the back of the Console Base (1) in the locations shown by the arrows in drawing 4a. If the connectors do not fit together easily, rotate them and then connect them.

See inset drawing 4c. Loop the included plastic tie through the square hole on the top and around the Wire Harness

(22)as shown. Tighten the plastic tie and cut off the end.

5.Insert the hinge of the Battery Cover (8) into the Console Plate (4) in the location shown; the Battery Cover should pivot on its hinge. Set the Console Base (1) on the Console Plate. Make sure the Wire Harness (22) is clear of the square battery access hole and the boss (see drawing 4a above). Make sure that no wires will be pinched before attaching the Console Base to the Console Plate. Tighten five Screws (5) into the Console Plate and the Console Base in the locations shown.

The console requires two "AA" batteries (not included). Alkaline batteries are recommended. Touch the Left Handrail (6) to discharge any static. Next, open the Battery Cover (8). Press two batteries into the battery com- partment, with the negative (–) ends of the batteries touch- ing the springs. Close the battery cover, push up on the tab, and then push the tab forward as shown in the inset drawing. Make sure that the tab locks into place.

6.Make sure that the Latch Pin (69) is in the Storage Latch

(41)as shown.

Attach the Storage Latch (41) to the Frame (55) with the three Screws (5). Do not tighten the Screws yet. Position the Storage Latch so that the Latch Pin (69) is aligned with the hole in the Left Handrail (7). Slide the Latch Pin into the hole as shown in the inset drawing. Then, tighten the three Screws.

4a			1
	22
	Battery	Boss
	Acess
6	4	11
			7
		9
4b	Tabs	4c	Square Hole
		6
			22
			Tie
		Remove Tie

5
1	5	4	5
			6
	8		5
7	5
	Batteries	8
			Tab
6
	55
	41	41	69
5		Hole
	69
		7

7.Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet, place a mat under the treadmill.

6