5.Hold a Handrail (32) near the Right Upright (6). Feed the Wire Harness (22) into the hole near the lower end of the Handrail and out the hole near the upper end of the Handrail. Note: It may be helpful to use needlenose pliers to pull the end of the Wire Harness out of the hole.
6.Open part bag C. Hold the Handrail (32) with the Wire Harness (22) against the Right Upright (6). Hand tighten two 2” Bolts (12) with two 3/8” Star Washers (42) into the Handrail and the Right Upright. Be careful not to pinch the Wire Harness. Do not tighten the Bolts yet.
Attach the other Handrail (not shown) to the Left Upright
(17)as described above. Note: There is not a wire on the left side. Do not tighten the Bolts yet.
Orient a Weight Rack (71) as shown, and attach it to the Right Upright (6) with six Rack Screws (21). Start all six
Screws before tightening them; do not overtighten the Screws.
Attach the other Weight Rack (not shown) to the Left Upright (17) as described above.
7.Hold the Console Base (77) near the Handrails (32) (only one is shown). Insert the Wire Harness (22) through the looped plastic tie and through the hole in the Console Base. Remove the tape holding the ends of the wires.
8
5 |
6 |
22 |
22 |
32 |
6 |
22 |
32 |
17 |
6 |
22 |
71 |
21 |
42 |
12 |
21 |
21 |
7 |
Tape 
7722 
32
|
|
|
| 22 |
| Tie | |||
|
|
|
|
|
|
|
|
| |
22 |
|
|
| |
|
|
|
|
|
