3.Have a second person hold the Base (46) in a vertical position as shown. Hold the Right Upright (62) against the Base so the indicated large hole is in the position shown. Attach the Right Upright with two Upright Bolts (65), two 3/8” Washers (66), and two 3/8” Nuts (61) as shown. Do not tighten the Upright Bolts yet.
Attach the Left Upright (not shown) to the Base (46) in the same way. Note: The Left Upright does not have a large hole.
4.Hold a Frame Spacer (27) against the right side of the Frame (79) as shown. Insert a Frame Bolt (70) into the frame bolt hole in the Upright Spacer and the Frame.
Next, tighten a Spacer Screw (45) into the Upright Spacer and the Frame. Then, remove the Frame Bolt. Repeat this step on the other side of the Frame.
5.Position the Base (46) over the Frame (79) as shown. Insert the Wire Harness (60) into the large hole in the Right Upright (62) and out of the top.
6.Raise the Right Upright (62) and the Left Upright (not shown) so the Base (46) is flat on the floor. Make sure that the upper end of the Wire Harness (not shown) does not fall into the Right Upright.
With the help of a second person, lift and hold the Frame (79) between the Right Upright (62) and the Left Upright (not shown). Finger tighten a Frame Bolt (70) with a Washer (66) and a 3/8” Star Washer (29) through the Right Upright and the Frame Spacer (27) and into the Frame. Do not tighten the Frame Bolt yet. Repeat this step on the left side of the treadmill.
3 |
|
66 | |
65 | 61 |
| |
62 |
|
| 46 |
Large | 65 66 |
| |
Hole |
|
4 |
|
| 27 |
| 45 |
| 70 |
79 |
|
5 |
|
62 |
|
| 46 |
| 60 |
Large | |
79 | Hole |
6 |
|
62 |
|
| 46 |
| 29 |
| 66 |
27 | 70 |
| |
79 |
|
7
