10.Set the Console (55) in the Console Base (52). Make sure that no wires are pinched. Insert as much of the Wire Harness (60) as possible down into the hole in the right Handrail (59). Securely tighten the plastic tie nearest to the right Handrail. Next, pull any excess Wire Harness between the plastic ties tight, and tighten the other plastic tie. Cut off the ends of the plastic ties.
Attach the Console (65) to the Console Base (52) with five 3/4” Screws (2) in the locations shown. Note: There should not be a Screw in the hole indicated by the arrow. Do not overtighten the Screws.
11.Lower the Uprights (53, 62) until the Handrails (59) are touching the floor.
See the lower drawing. Position the Uprights (53, 62) so the treadmill Frame (79) is centered between them.
Firmly tighten the four Upright Bolts (65) and the two Frame Bolts (70). Be careful not to overtighten the
Frame Bolts.
12.With the help of a second person, carefully raise the Left Upright (53) and Right Upright (not shown), to a vertical position. Attach the Storage Latch (48) to the Left Upright (53) with two 3/4” Screws (2).
10 |
|
|
|
|
| No | 55 |
| 52 | Screw | |
|
| ||
Ties | 2 |
|
|
|
|
| |
| 60 |
|
|
| 2 |
| 2 |
|
|
| |
| 59 |
|
|
11 |
| 70 |
|
| 53, 62 |
|
|
65 
59
Top View
62 | 53 |
| 79 |
12 |
|
| 53 |
48 | 2 |
13.Make sure that all parts used in assembly are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place; the allen wrench is used to adjust the walking belt (see page 17). To protect the floor or carpet, place a mat under the treadmill.
9
