To stop the walking belt, press the Stop button. The Time/Distance display will begin to flash.
Note: During the first few minutes that the treadmill is used, inspect the alignment of the walking belt, and align it if necessary (see page 13).
3 Change the incline of the treadmill as desired.
To change the incline of the treadmill, press either of the Incline buttons until the desired incline level is reached.
4 Follow your progress with the three displays. Time/Distance
and the distance that you have walked or run. The display will change
from one number to the
other every few seconds, as shown by the mode indicators. When the Stop button is pressed, the display will flash.
Fat Calories/Calories/
Pulse
FAT BURNING on page 14). The display will change from one number to the other every few seconds, as shown by the mode indicators. The display will also show your heart rate when you use the heart rate sensor (see step 5).
Speed
Note: The console can
display speed and dis- tance in either miles or kilometers. To change the unit of measure-
ment, hold down the
Stop button, insert the key into the console, and continue to hold the Stop button for a moment. An
“E” for English miles or an “M” for metric kilometers will appear in the Fat Calories/Calories/Pulse dis- play. Press the Speed ▲ button to change the unit of measurement. When the desired unit of mea- surement is selected, remove the key and then reinsert it.
To reset the displays, press the Stop button, re- move the key, and then reinsert the key.
5 Measure your heart rate, if desired.
To measure your heart rate, stand on the foot rails and place your thumb on the heart rate sensor. Do not
press too hard, or the circulation in
your thumb will be restricted and your pulse will not be detected. After a few seconds, the
If the displayed heart rate appears to be too high or too low, or if your heart rate is not displayed, lift your thumb off the heart rate sensor for a few sec- onds. Then, place your thumb on the heart rate sensor as described above. Remember to stand still while measuring your heart rate.
6 Whenkey. you are finished exercising, remove the
Step onto the foot rails, press the Stop button, and remove the key from the console. Keep the key in a secure place.
WARNING: Removing the key does not cut off power to the incline sys- tem. To prevent movement of the treadmill and possible injury, unplug the power cord when the treadmill is not in use.
10
