6.Place the Console Base (46) on the Right Handrail (47) and the Left Handrail (not shown). Touch the Right
Upright (62) to discharge any static.
Hold the Console (10) near the Console Base (46). Insert the Wire Harness (21) through the two indicated plastic ties on the Console Base. Next, insert the Wire Harness up through the indicated opening in the Console Base and through the plastic tie on the bottom of the Console.
Plug the widest connector on the Wire Harness (21) into the widest connector on the Console (10). If the connec- tor does not fit easily, rotate it and then connect it.
Plug the other connector on the Wire Harness into the other connector on the Console. Note: The locations of the connectors are shown by arrows.
Securely tighten the plastic tie on the Console (10) to prevent the Wire Harness (21) from slipping. Then, cut off the end of the plastic tie.
7.Set the Console (10) in the Console Base (46). Be careful to avoid pinching any wires. Insert the excess Wire Harness (21) into the large hole in the side of the Right Handrail (47). Securely tighten the plastic ties on the bottom of the Console Base to prevent the Wire Harness from slipping. Cut off the ends of the plastic ties.
Attach the Console (10) to the Console Base (46) with seven 3/4” Screws (13). Make sure that no wires are pinched. Start all seven Screws before tightening them; do not overtighten the Screws.
Attach the Console Base (46) to the Left and Right Handrails (1, 47) with four 3/4” Screws (13).
8.Attach the Storage Latch (14) to the left Upright (76) with two 3/4” Screws (13). Be careful not to overtighten the
Screws.
Lift the treadmill frame (see HOW TO FOLD THE TREADMILL FOR STORAGE on page 11), but do not latch it. Make sure that the frame is centered between the Handrails (1, 47 [not shown]). Firmly tighten all of the bolts and screws used in assembly steps 3, 4, and 5. Then, lower the frame to the floor.
6 | 10 |
|
|
| |
| Tie |
|
46 | 21 |
|
47 | Ties |
|
|
| |
62 |
| 21 |
|
| |
7 | 46 | 10 |
| 1 | |
Ties |
| |
|
| |
21 |
| 13 |
13 | 47 | 13 |
| ||
8 |
|
|
1 |
|
|
|
| 76 |
14 |
| |
|
| 13 |
9.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet, place a mat under the treadmill.
7
