3.With the help of a second person, tip the treadmill so the Base Pads (40) (see drawing 1) are laying flat on the

floor. Rraise the Uprights (62, 76) to the vertical position.

Hold the Crossbar (34) between the Uprights (62, 76). Attach the Crossbar with two 2 1/2” Bolts (53) and two 5/16” Washers (57)Do. not tighten the Bolts yet.

4.Feed the Wire Harness (21) up into the rectangular bracket on one of the Handrails (1) and out of the large hole in the left side. Note: It may be helpful to use needlenose pliers to pull the Wire Harness out of the large hole.

Remove any plastic ties from the rectangular bracket on

the Handrail (1). Insert the bracket into the upper end of the Right Upright (62). Attach the ends of the Handrail to the Right Upright with two 1” Bolts (8). Do not tighten the Bolts yet.

Attach the other Handrail (1) as described above. Note: There is not a wire harness on the left side.

Open part bag C. Attach the end of the ground wire to the small hole in the side of the right Handrail (1) with a Silver Screw (70).

5. Place the Console Base (46) on the right Handrail (1)

and the left Handrail (not shown). Touch the Right

Upright (62) to discharge any static.

Hold the Console (10) near the Console Base (46). Insert the Wire Harness (21) through the two indicated plastic ties on the Console Base. Next, insert the Wire Harness

up through the indicated opening in the Console Base

and through the plastic tie on the bottom of the Console.

Plug the widest connector on the Wire Harness (21) into

the widest connector on the Console (10). The connec- tors should slide together easily and snap into place.

If they do not, turn the connector on the Wire Harness and try again. Plug the other connector on the Wire Harness into the other connector on the Console. Note: The locations of the connectors are shown by arrows.

Securely tighten the plastic tie on the Console (10) to

prevent the Wire Harness (21) from slipping.Then, cut off the end of the plastic tie.

3

 

 

 

53

34

 

 

57

 

 

 

 

 

 

57

 

76

 

53

 

 

 

 

 

62

 

4

 

 

 

1

8

Ground

21

Wire

 

 

 

 

 

70

 

 

Large

 

8

 

Hole

 

 

1

 

 

 

76

 

Bracket

 

 

 

 

 

62

 

8

 

 

 

 

8

 

 

5

10

 

 

 

 

 

 

Tie

 

 

46

21

 

 

 

 

 

1

Ties

21

 

 

 

 

62

 

 

 

6

Page 6
Image 6
Weslo WLTL29321 Floor. Rraise the Uprights 62, 76 to the vertical position, Upright 62 to discharge any static, Tie Ties